Sheet metal punches GN 123 allow the operator to easily punch mounting holes in sheet metal doors, for cam latches with square V14 and V20.
These punches are ideally suited for punching holes into sheet metal up to 2 mm thickness.
Assembly instructions
For drilling a pilot hole (d) we recommend using sticky tape marked with the center drilling and datum line.
Insert the pulling bolt with the punch and add the die, aligning the latter with the datum line and holding it in position with the hex nut; commence the punching operation.
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 1.047 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 800-877-8351
